LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> NX 200t Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostics - Introduction (4 Of 4) >> Meter / Gauge System >> Data List / Active Test [09/2017 - 05/2019] >> Data List / Active Test [09/2017 - 05/2019]

Data List / Active Test [09/2017 - 05/2019]

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus:
      1. for Combination Meter: Body Electrical / Combination Meter / Data List.
      2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.
      3. for Engine: Powertrain / Engine / Data List.
    6. Check the values by referring to the table below.
      1. Combination Meter

        Body Electrical > Combination Meter > Data List 

        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        ODO/TRIP Change SW ODO/TRIP switch OFF or ON OFF: ODO/TRIP switch released
        ON: ODO/TRIP switch pushed
        -
        P-Seatbelt Buckle SW Front passenger seat belt buckle switch OFF or ON OFF: Front passenger seat belt fastened
        ON: Front passenger seat belt unfastened
        -
        Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed -
        Engine Rpm Engine speed Min.: 0 rpm, Max.: 12750 rpm Actual engine speed -
        Coolant Temperature Engine coolant temperature Min.: 0°C (0°F), Max.: 127.5°C (261.5°F) 75 to 100°C (167 to 212°F): After warming up the engine -
        Washer Switch Washer fluid level warning switch OFF or ON OFF: Washer fluid level not low
        ON: Washer fluid level low
        -
        Oil Level SW Engine oil level sensor OFF or ON OFF: Engine oil level not low
        ON: Engine oil level low
        -
        Light Control Up Switch Light control rheostat up switch OFF or ON OFF: Light control rheostat up switch released
        ON: Light control rheostat up switch pushed
        -
        Light Control Down Switch Light control rheostat down switch OFF or ON OFF: Light control rheostat down switch released
        ON: Light control rheostat down switch pushed
        -
        +B Voltage Value Battery voltage Min.: 0 V, Max.: 25.5 V 11 to 14 V -
        Fuel Input Fuel input Min.: 0, Max. 127.5 Current fuel level displayed Unit: Liter
        Ambient Temperature Outside temperature Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature -
        Multi Switch (Up) Steering pad switch (Up) OFF or ON OFF: Steering pad switch (Up) released
        ON: Steering pad switch (Up) pushed
        -
        Multi Switch (Down) Steering pad switch (Down) OFF or ON OFF: Steering pad switch (Down) released
        ON: Steering pad switch (Down) pushed
        -
        Multi Switch (Menu) Steering pad switch (Menu) OFF or ON OFF: Steering pad switch (Menu) released
        ON: Steering pad switch (Menu) pushed
        -
        Multi Switch (Enter) Steering pad switch (Enter) OFF or ON OFF: Steering pad switch (Enter) released
        ON: Steering pad switch (Enter) pushed
        -
        Multi Switch (Right) Steering pad switch (Right) OFF or ON OFF: Steering pad switch (Right) released
        ON: Steering pad switch (Right) pushed
        -
        Multi Switch (Left) Steering pad switch (Left) OFF or ON OFF: Steering pad switch (Left) released
        ON: Steering pad switch (Left) pushed
        -
        2nd-Row Seatbelt Buckle (R) Rear seat belt buckle switch RH OFF or ON OFF: Rear seat belt RH fastened
        ON: Rear seat belt RH unfastened
        -
        2nd-Row Seatbelt Buckle (L) Rear seat belt buckle switch LH OFF or ON OFF: Rear seat belt LH fastened
        ON: Rear seat belt LH unfastened
        -
        2nd-Row Seatbelt Buckle (C) Rear seat belt buckle switch center OFF or ON OFF: Rear seat belt center fastened
        ON: Rear seat belt center unfastened
        -
        Oil Pressure Switch Engine oil pressure switch OFF or ON OFF: Engine oil pressure not low
        ON: Engine oil pressure low
        -
        Turn Signal Switch (Right) Turn signal switch (right) OFF or ON OFF: Turn signal switch (right) off
        ON: Turn signal switch (right) on
        -
        Turn Signal Switch (Left) Turn signal switch (left) OFF or ON OFF: Turn signal switch (left) off
        ON: Turn signal switch (left) on
        -
        Hazard Flasher Switch Hazard warning signal switch OFF or ON OFF: Hazard warning signal switch off
        ON: Hazard warning signal switch on
        -
        Passenger Occupant Detection Switch Front passenger side occupant detection sensor OFF or ON OFF: Front passenger seat not occupied
        ON: Front passenger seat occupied
        -
        Turn Switch Signal (Full Turn) Turn signal switch status OFF or ON OFF: Turn signal switch off
        ON: Turn signal switch on (Full Turn)
        -
        Multi Switch (Back) Steering pad switch (Back) OFF or ON OFF: Steering pad switch (Back) released
        ON: Steering pad switch (Back) pushed
        -
        Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer OFF or ON Customized value displayed -
        P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer OFF or ON Customized value displayed -
        ODO Display Time After IG OFF Setting Condition of the ODO display time after the engine switch is turned off 30s, 60s, 600s, OFF Customized setting displayed -
        Flasher Sound Volume Adjustment Condition of the flasher sound volume adjustment Small, Medium, Large Customized setting displayed -
        TPMS System Existence of function With/Without With: w/ Tire pressure warning system
        Without: w/o Tire pressure warning system
        -
        LDA System Existence of function With/Without With: w/ Lane departure alert system
        Without: w/o Lane departure alert system
        -
        VSC System Existence of function With/Without With: w/ Vehicle stability control system
        Without: w/o Vehicle stability control system
        -
        PCS System Existence of function With/Without With: w/ Pre-collision system
        Without: w/o Pre-collision system
        -
        Radar Cruise System Existence of function With/Without With: w/ Dynamic radar cruise control system
        Without: w/o Dynamic radar cruise control system
        -
        Number of Trouble Code The number of the DTC currently stored Min.: 0, Max.: 255 0 -
      2. ABS/VSC/TRAC

        Chassis > ABS/VSC/TRAC > Data List 

        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -
      3. Engine

        Powertrain > Engine > Data List 

        Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note
        Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm Actual engine speed -
        Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max: 215°C (419°F) 75 to 100°C (167 to 212°F): After warming up the engine -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. Check the operation by referring to the table below.

      Body Electrical > Combination Meter > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Speed Meter Operation Speedometer
      • OFF, 0, 40, 80, 120, 160, 200, 240 (km/h) (with km/h units)
      • OFF, 0, 40, 80, 120 (mph) (with mph units)
      There is a deviation in the values displayed on the speedometer display (Control range → Speedometer)
      with km/h units: 
      • 40 → 38.2 to 42.7
      • 80 → 78.3 to 83.3
      • 120 → 118.7 to 123.7
      • 160 → 159.1 to 164.1
      • 200 → 199.5 to 204.5
      • 240 → 239.9 to 244.9

      with mph units: 
      • 40 → 39.0 to 41.8
      • 80 → 79.2 to 82.4
      • 120 → 119.6 to 122.8
      TachoMeter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 (rpm) -
      Fuel Meter Operation Fuel receiver gauge OFF, Sender, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F -
      A/T Indicator Operation 1 Shift indicator OFF, L, 2, 3, 4, D, N, R, P -
      A/T Indicator Operation 2 Shift indicator OFF, 8, 5, 6, 7, S, M -
      A/T Indicator Operation 3 Shift indicator OFF, D -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Driver Side Seat Belt Driver seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Head Headlight indicator light OFF or ON with mph units
      Indicat. Lamp Tail Tail indicator light OFF or ON with km/h units
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON -
      Indicat. Precrash PCS OFF indicator light OFF or ON w/ Pre-collision System
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -
      Indicat. ECONO Eco driving indicator light OFF or ON -
      Indicat. Lamp Brake BRAKE warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. INTUITIVE P/A LCD Clearance sonar indicator light OFF or ON w/ Intuitive Parking Assist System
      Indicat. Brake Hold Brake hold standby indicator light OFF or ON -
      Indicat. Hold Brake hold operated indicator light OFF or ON -
      Indicat. Park Parking brake warning light OFF or ON -
      Indicat. Ctr DIFF LOCK AWD indicator light OFF or ON for AWD
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Automatic High Beam Indicator Automatic high beam indicator light OFF or ON w/ Automatic High Beam System
      Turn Signal (Left) Indicator Turn Indicator light (LH) OFF or ON -
      Turn Signal (Right) Indicator Turn Indicator light (RH) OFF or ON -
      Check Engine Indicator MIL (Malfunction indicator lamp) OFF or ON -
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH -
      Meter Display 1 Multi-information display OFF, All -