Only Front Switch Cannot Operate Rear Sunshade [10/2014 - ]: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [10/2014 - ] .
2. Check for DTCs. Refer to DTC CHECK / CLEAR [10/2014 - ] .
   RESULT
   
   

   Result	Proceed to
   No DTC is output	A
   DTC U1114 is output	B
   DTC U1127 is output	C

B → See step   5 

C → See step   6 

A: Go to next step 

1. Use the Data List to check if the rear sunshade switch is functioning properly. Refer to DATA LIST / ACTIVE TEST [10/2014 - ] .
   CENTER CONSOLE SWITCH
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Rear Shade Switch	Rear sunshade switch / ON or OFF	ON: Rear sunshade switch pressed OFF: Rear sunshade switch not pressed	-

   OK

   On the Techstream screen, item changes between ON and OFF according to above chart.

NG → See step   4 

OK: Go to next step 

1. Temporarily replace the combination switch assembly with a new one or normally functioning one. Refer to REMOVAL [10/2014 - ] .
2. Check the rear sunshade system operate normally. Refer to OPERATION CHECK [10/2014 - ] .

   OK

   Rear sunshade raises or lowers.

NG → See step   9 

OK → END (COMBINATION SWITCH ASSEMBLY IS DEFECTIVE) 

1. Remove the integration control and panel assembly. Refer to REMOVAL [10/2014 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   z75-3 - z75-9	Rear sunshade switch is pushed	Below 200 Ω
   z75-3 - z75-9	Rear sunshade switch is not pushed	10 kΩ or higher

NG → See step   7 

OK → See step   8