Installation [10/2014 - ]
- INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
- INSTALL NO. 2 INSTRUMENT PANEL WIRE
- Connect the 2 airbag connectors.
NOTE:
- When connecting airbag connector, take care not to damage the airbag wire harness.
- Be sure to only connect the connectors to each corresponding color.
- Push in the lock to connect the airbag connector.
- Attach the clamp to install the No. 2 instrument panel wire to the front passenger airbag assembly.
- Connect the 2 airbag connectors.
- INSTALL NO. 3 HEATER TO REGISTER DUCT . Refer to REASSEMBLY [10/2014 - ] - Step 13
- INSTALL DEFROSTER NOZZLE ASSEMBLY . Refer to REASSEMBLY [10/2014 - ] - Step 12
- INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT . Refer to REASSEMBLY [10/2014 - ] - Step 15
- INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to INSTALLATION [10/2014 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [10/2014 - ] .
- CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [10/2014 - ]
- INSTALL COWL TOP VENTILATOR LOUVER RH . Refer to INSTALLATION [10/2014 - ] - Step 17