DTC P0010: Camshaft Position "A" Actuator Circuit (Bank 1); DTC P0020: Camshaft Position "A" Actuator Circuit (Bank 2) [10/2014 - ]: Procedure
- INSPECT CAMSHAFT TIMING GEAR ASSEMBLY (BANK 1 OR BANK 2)
- Turn the engine switch off.
- Remove the camshaft timing control motor. Refer to REMOVAL [10/2014 - ] .
- Check if the camshaft timing gear assembly's eccentric shaft rotates smoothly.
OK
Rotates smoothly
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly. Refer to INITIALIZATION [10/2014 - ] .
NG → See step 2
OK → See step 3
- REPLACE CAMSHAFT TIMING GEAR ASSEMBLY (BANK 1 OR BANK 2). Refer to DISASSEMBLY [10/2014 - ]
- REPLACE CAMSHAFT TIMING CONTROL MOTOR (BANK 1 OR BANK 2). Refer to REMOVAL [10/2014 - ]