LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 350 Base, RWD >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Drive Shaft / Propeller Shaft - Service Information >> FRONT DRIVE SHAFT ASSEMBLY (for AWD) >> Removal [08/2015 - 09/2020] >> Procedure

Removal [08/2015 - 09/2020]: Procedure

  1. REMOVE FRONT WHEEL 
  2. DRAIN DIFFERENTIAL OIL 

    Refer to PROCEDURE - Step 1 [08/2015 - 10/2017] , or refer to PROCEDURE - Step 1 [10/2017 - ]

  3. REMOVE FRONT AXLE SHAFT NUT 

    Refer to PROCEDURE - Step 4 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 4 [10/2016 - 09/2020]

  4. SEPARATE FRONT SPEED SENSOR 

    Refer to PROCEDURE - Step 3 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 3 [10/2016 - 09/2020]

  5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY 

    Refer to PROCEDURE - Step 2

  6. REMOVE FRONT DISC 

    Refer to PROCEDURE - Step 7

  7. SEPARATE FRONT LOWER BALL JOINT ASSEMBLY 

    Refer to PROCEDURE - Step 11 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 11 [10/2016 - 09/2020]

  8. SEPARATE FRONT DRIVE SHAFT ASSEMBLY 
    1. Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.
      GTY461729Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark
    2. Using a plastic hammer, separate the front drive shaft assembly from the front axle hub sub-assembly.
      NOTE:

      Be careful not to damage the front axle outboard joint boot.

      HINT: 

      If it is difficult to separate the front drive shaft assembly from the front axle hub sub-assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.

  9. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH 
    1. Using SST, remove the front drive shaft assembly LH.
      GTY471038Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09520-01010 
      • SST: 09520-24010 
        1. 09520-32040
      NOTE:
      • Do not damage the front differential case oil seal.
      • Do not damage the front axle inboard joint boot.
      • Do not drop the front drive shaft assembly LH.
  10. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH 
    GTY400285Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using water pump pliers, remove the drive shaft bearing bracket hole snap ring.
    2. Remove the No. 1 drive shaft bearing bracket setting bolt and front drive shaft assembly RH.
      NOTE:
      • Do not damage the front differential case oil seal.
      • Do not damage the front axle inboard joint boot.
      • Do not drop the front drive shaft assembly RH.
  11. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH 
    1. Using a screwdriver, remove the front drive shaft hole snap ring LH.
      GTY106453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals