LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 250 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Engine Lubrication System (2GR-FSE) - Service Information) >> Oil Level Sensor >> Removal [10/2016 - 10/2017] >> Procedure

Removal [10/2016 - 10/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Lexus IS 350, 2017 Lexus IS 300, 2016 Lexus IS 350, 2016 Lexus IS 300, and 2015 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE OIL 

    See step  1

  2. REMOVE FRONT SUSPENSION MEMBER BRACE (for 2WD) 

    Refer to PROCEDURE - Step 13

  3. REMOVE ENGINE OIL LEVEL SENSOR 
    1. Disconnect the engine oil level sensor connector.
      GTY462985Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A For 2WD
      *B For AWD
      Bolt
      Connector
    2. Remove the 4 bolts and engine oil level sensor.
    3. Cut off the gasket as shown in the illustration.
      GTY466026Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Cutting Position
      *2 Supply Part
    4. Remove the gasket from the engine oil level sensor.

      HINT: 

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.

scientia non olet · About LEMON Manuals