LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 250 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Mechanical System (2GR-FSE) - Service Information (1 Of 2)) >> Drive Belt >> Removal [04/2013 - 10/2017] >> Procedure

Removal [04/2013 - 10/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Lexus IS 350, 2017 Lexus IS 300, 2016 Lexus IS 350, 2016 Lexus IS 300, and 2015 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 1 [10/2016 - 09/2020]

  2. REMOVE INLET NO. 1 AIR CLEANER 

    See step  20[04/2013 - 08/2015], or see step  20[08/2015 - 10/2016], or see step  19[10/2016 - 10/2017]

  3. REMOVE V-BANK COVER SUB-ASSEMBLY 

    See step  3[04/2013 - 08/2015], or see step  3[08/2015 - 10/2016], or see step  3[10/2016 - 10/2017]

  4. REMOVE V-RIBBED BELT 
    1. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, remove the V-ribbed belt from the V-ribbed belt tensioner assembly.
      GTY460162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. While turning the V-ribbed belt tensioner assembly counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to secure the V-ribbed belt tensioner assembly.
      GTY465689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 5 mm Bi-hexagon Wrench
scientia non olet · About LEMON Manuals