Removal [08/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 3 [08/2015 - 10/2016]
, or refer to PROCEDURE - Step 3 [10/2016 - 09/2020]
, or refer to PROCEDURE - Step 3 [09/2020 - ]
- REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
NOTE:
If a camshaft position sensor has been struck or dropped, replace it.
- REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)
- Disconnect the fuel pump assembly connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
NOTE:
If a camshaft position sensor has been struck or dropped, replace it.