LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 250 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical System (4GR-FSE) - Service Information (1 Of 2) >> Drive Belt >> Removal [04/2013 - 08/2015] >> Procedure

Removal [04/2013 - 08/2015]: Procedure

  1. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1

  2. REMOVE INLET NO. 1 AIR CLEANER 

    See step  20

  3. REMOVE V-BANK COVER SUB-ASSEMBLY 

    See step  3

  4. REMOVE V-RIBBED BELT 
    1. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, remove the V-ribbed belt from the V-ribbed belt tensioner assembly.
      GTY460162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. While turning the V-ribbed belt tensioner assembly counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to secure the V-ribbed belt tensioner assembly.
      GTY465689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 5 mm Bi-hexagon Wrench
scientia non olet · About LEMON Manuals