LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 250 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (4GR-FSE) - Service Information >> Oil Pressure Switch >> Installation [04/2013 - 08/2015] >> Procedure

Installation [04/2013 - 08/2015]: Procedure

  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Clean and degrease the threads of the engine oil pressure switch assembly.
    2. Apply adhesive 1324 to 2 or 3 threads of the engine oil pressure switch assembly.
      GTY464592Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Adhesive 1324

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      NOTE:
      • Install the engine oil pressure switch assembly within 3 minutes after applying adhesive.
      • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
    3. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Type A 

      Torque: 14.7 N.m (150 kgf/cm, 11 ft.lbf) 

      Type B 

      Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

      NOTE:

      Do not start the engine for at least 1 hour after installation.

      GTY463876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Type A
      *b Type B
    4. Connect the engine oil pressure switch assembly connector.
  2. ADD ENGINE OIL 

    See step  7

  3. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  4. INSPECT FOR ENGINE OIL LEAK 

    See step  8

  5. INSTALL NO. 1 AIR CLEANER INLET 

    Refer to PROCEDURE - Step 74

  6. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

scientia non olet · About LEMON Manuals