LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 250 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (4GR-FSE) - Service Information >> Oil Level Sensor >> Removal [04/2013 - 08/2015] >> Procedure

Removal [04/2013 - 08/2015]: Procedure

  1. DRAIN ENGINE OIL 

    See step  1

  2. REMOVE FRONT SUSPENSION MEMBER BRACE (w/ No. 2 Engine Under Cover) 

    Refer to PROCEDURE - Step 13

  3. REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover) 

    Refer to PROCEDURE - Step 14

  4. REMOVE ENGINE OIL LEVEL SENSOR 
    1. Disconnect the engine oil level sensor connector.
      GTY462986Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for 2WD
      *B for AWD
    2. Remove the 4 bolts and engine oil level sensor.
    3. Cut off the gasket as shown in the illustration.
      GTY466027Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Cutting Position
      *2 Supply Part
    4. Remove the gasket from the engine oil level sensor.

      HINT: 

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.

scientia non olet · About LEMON Manuals