Meter Illumination is Always Dark [04/2013 - 10/2016]: Procedure

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [04/2013 - 06/2014] , or refer to DIAGNOSIS SYSTEM [06/2014 - 08/2015] , or refer to DIAGNOSIS SYSTEM [08/2015 - 10/2016]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2013 - 10/2016] 

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Check the values by referring to the table below.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Light Sensor Illuminance	Light sensor illuminance	0 lx to 8191 lx	Value output according to ambient light levels	-

   Body Electrical > Main Body > Data List 

   Tester Display
   Light Sensor Illuminance

   Result

   Result	Proceed to
   The output value changes according to the ambient light level.	A
   The output value does not change according to the ambient light level.	B

Result: 

B 

CHECK CUSTOMIZE PARAMETER SETTING (SENSITIVITY). Refer to  CUSTOMIZE PARAMETERS [04/2013 - 10/2016] 

Result: 

A 

See step  3

1. Replace the main body ECU (multiplex network body ECU) with a new or known good one.

   Refer to REMOVAL [04/2013 - ]

   OK

   The operation of the combination meter assembly returns to normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [04/2013 - 10/2016]