Installation [08/2013 - ]

INSTALL COMBINATION METER ASSEMBLY
1. Connect the connector.
  
  Fig 1: Locating Combination Meter Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 2 clips.
  
  Fig 2: Identifying Combination Meter Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the combination meter with the 2 screws.
  
  Fig 3: Identifying Combination Meter Assembly And Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
1. Attach the 5 claws to install the register.
  
  Fig 4: Identifying No. 3 Instrument Panel Register Assembly And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
1. Attach the 4 claws to install the register.
  
  Fig 5: Identifying No. 1 Instrument Panel Register Assembly And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Connect the connectors.
  
  Fig 6: Identifying Finish Panel And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 4 claws to install the finish panel.
3. Attach the 6 claws.
  
  Fig 7: Identifying Instrument Cluster Finish Panel Sub-Assembly And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
1. Connect the connector.
  
  Fig 8: Identifying Lower Instrument Panel Pad Sub-Assembly LH And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 8 claws to install the instrument panel pad.
INSTALL NO. 1 SWITCH HOLE BASE
1. Connect the connectors.
  
  Fig 9: Identifying No. 1 Switch Hole Base And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 5 claws to install the hole base.
INSTALL INSTRUMENT SIDE PANEL LH
1. Attach the 6 claws to install the side panel.
  
  Fig 10: Identifying Instrument Side Panel LH And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS [08/2013 - ] .
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .
INSTALL ENGINE ROOM SIDE COVER LH . Refer to INSTALLATION [08/2013 - ] - Step 3