Removal [09/2013 - ]

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE STEERING COLUMN COVER . Refer to REMOVAL [09/2013 - ] - Step 1
REMOVE FRONT DOOR SCUFF PLATE LH . Refer to REMOVAL [09/2013 - ] - Step 40
REMOVE FRONT DOOR OPENING TRIM COVER LH . Refer to REMOVAL [09/2013 - ] - Step 42
REMOVE SIDE INSTRUMENT PANEL LH . Refer to REMOVAL [09/2013 - ] - Step 26
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 28
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Disengage the 2 clips.
  
  Fig 1: Identifying Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws and remove the instrument cluster finish panel sub-assembly.
  
  Fig 2: Identifying Instrument Cluster Finish Panel Subassembly With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 2
REMOVE COMBINATION METER ASSEMBLY
1. Attach protective tape to the position indicated in the illustration.
  
  Fig 3: Attaching Protective Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver, disengage the claw.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 4: Disengage Claw Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, disengage the claw and pull out the combination meter assembly.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 5: Disengage Claw Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the connectors and remove the combination meter assembly as shown in the illustration.
  
  Fig 6: Removing Combination Meter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Do not damage the instrument panel safety pad or combination meter assembly when removing the combination meter assembly.