Inspection [04/2013 - 08/2015]: Procedure

1. Inspect the tires for wear and proper inflation pressure.

   Cold Tire Inflation Pressure

   Tire Size		Tire Inflation Pressure
   Front	Rear	Front	Rear
   205/55R16 91W		250 kPa (2.5 kgf/cm2 , 36 psi)
   225/45R17 91W
   225/45R17 91V
   225/40R18 88Y	255/35R18 90Y
   225/40R18 88W	255/35R18 90W

2. Using a dial indicator, check the runout of the tires.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Maximum Tire Runout

   1.0 mm (0.0394 in.)

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Front

   Except 18 Inch Wheel

   1. Rotate the tires as shown in the illustration.

      Axle hub nut 

      Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

2. For 18 Inch Wheel

   HINT: 

   Tire rotation cannot be performed on this vehicle.

1. Inspect and adjust the off-the-car balance.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	For 16 Inch Wheel
   *B	Except 16 Inch Wheel
   *a	25 mm (0.984 in.)

   Maximum Imbalance

   8.0 g (0.0176 lb)

   NOTE:

   • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
   • Do not touch the adhesive surface of the balance weight.
   • Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.
   • Push the balance weight with your finger to securely adhere it to the desired position.
   • Do not reuse balance weights.

   HINT: 

   • For 16 inch wheel: Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.
   • Except 16 inch wheel: Use stick-on type balance weights for both the inner and outer side.

Refer to ON-VEHICLE INSPECTION [04/2013 - 08/2015]

Refer to ON-VEHICLE INSPECTION [04/2013 - 09/2020]