Installation [10/2017 - 09/2020]: Procedure

1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.
   NOTE:

   Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   *b	Stopper
   	Front of the Vehicle

1. Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.
   NOTE:

   Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the front of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Arrow Mark
   	Front of the Vehicle

1. Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 bolts.

   Torque: 51 N.m (520 kgf/cm, 38 ft.lbf) 

   NOTE:

   • Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of B, C, D, and A.
   • Ensure that the identification mark is on the right side of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

Refer to PROCEDURE - Step 16

1. Install the rear stabilizer link assembly LH with the 2 nuts.

   Nut A 

   Torque: 89 N.m (908 kgf/cm, 66 ft.lbf) 

   Nut B 

   Torque: 70 N.m (714 kgf/cm, 52 ft.lbf) 

   NOTE:

   Ensure that the identification mark is on the upper side of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

Torque: 103 N.m (1050 kgf/cm, 76 ft.lbf)