Removal [09/2020 - ]: Procedure
- REMOVE REAR WHEEL
Refer to REMOVAL [09/2020 - ]
- SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)
See step 2
- SEPARATE TOE CONTROL LINK SUB-ASSEMBLY
See step 3
- REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY
- Remove the bolt and nut, and separate the rear No. 1 suspension arm assembly from the rear axle assembly.NOTE:
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
- Remove the bolt and nut, and remove the rear No. 1 suspension arm assembly from the rear suspension member sub-assembly.NOTE:
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
- Remove the bolt and nut, and separate the rear No. 1 suspension arm assembly from the rear axle assembly.
- REMOVE REAR SUSPENSION MEMBER BRACE
- REMOVE REAR STABILIZER LINK ASSEMBLY
See step 2
- SEPARATE REAR SHOCK ABSORBER ASSEMBLY
See step 6
- REMOVE REAR COIL SPRING
See step 7
- REMOVE REAR UPPER COIL SPRING INSULATOR
See step 8
- REMOVE REAR LOWER COIL SPRING INSULATOR
See step 9
- REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY