LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Starting System (2GR-FKS) - Service Information) >> Starter >> Removal [10/2017 - ] >> Procedure

Removal [10/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [10/2017 - 09/2020] , or refer to PRECAUTION [09/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2017 - 09/2020] , or refer to INITIALIZATION [09/2020 - 11/2021] , or refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

  3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst) 

    Refer to REMOVAL [10/2017 - ]

  4. REMOVE STARTER COVER 
    1. Remove the 2 bolts and starter cover.
      GTY627223Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter connector.
      GTY838166Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Open the terminal cap, remove the nut and disconnect the wire harness.
    3. Remove the 2 bolts and starter assembly.