Installation [10/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL STARTER ASSEMBLY
- Install the starter assembly with the 2 bolts.
Torque: 46 N.m (469 kgf/cm, 34 ft.lbf)
- Connect the wire harness, install the nut and close the terminal cap.
Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf)
- Connect the starter connector.
- Install the starter assembly with the 2 bolts.
- INSTALL STARTER COVER
- Install the starter cover with the 2 bolts.
Torque: 11.5 N.m (117 kgf/cm, 8 ft.lbf)
- Install the starter cover with the 2 bolts.
- INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst)
Refer to INSTALLATION [10/2017 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2017 - 09/2020] , or refer to INITIALIZATION [09/2020 - 11/2021] , or refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]