LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Starting System (4GR-FSE) - Service Information) >> Starter >> Removal [04/2013 - 08/2015] >> Procedure

Removal [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2013 - 08/2015]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015]

  3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH(TWC: Front Catalyst) 

    Refer to REMOVAL [04/2013 - 08/2015]

  4. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter connector.
      GTY462769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Terminal Cap
    2. Open the terminal cap, remove the nut and disconnect the wire harness.
    3. Remove the 2 bolts and starter assembly.