LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Starting System (4GR-FSE) - Service Information) >> Starter >> Installation [04/2013 - 08/2015] >> Procedure

Installation [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 58 N.m (591 kgf/cm, 43 ft.lbf) 

    2. Connect the wire harness, install the nut and close the terminal cap.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

    3. Connect the starter connector.
  2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH(TWC: Front Catalyst) 

    Refer to INSTALLATION [04/2013 - 08/2015]

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015]

scientia non olet · About LEMON Manuals