LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Lubrication System (4GR-FSE) - Service Information) >> Oil Pressure Switch >> Installation [04/2013 - 08/2015] >> Procedure

Installation [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Clean and degrease the threads of the engine oil pressure switch assembly.
    2. Apply adhesive 1324 to 2 or 3 threads of the engine oil pressure switch assembly.
      GTY464592Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Adhesive 1324

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      NOTE:
      • Install the engine oil pressure switch assembly within 3 minutes after applying adhesive.
      • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
    3. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Type A 

      Torque: 14.7 N.m (150 kgf/cm, 11 ft.lbf) 

      Type B 

      Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

      NOTE:

      Do not start the engine for at least 1 hour after installation.

      GTY463876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Type A
      *b Type B
    4. Connect the engine oil pressure switch assembly connector.
  2. ADD ENGINE OIL 

    See step  7

  3. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  4. INSPECT FOR ENGINE OIL LEAK 

    See step  8

  5. INSTALL NO. 1 AIR CLEANER INLET 

    Refer to PROCEDURE - Step 74

  6. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

scientia non olet · About LEMON Manuals