LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Lubrication System (4GR-FSE) - Service Information) >> Oil Level Sensor >> Installation [04/2013 - 08/2015] >> Procedure

Installation [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE OIL LEVEL SENSOR 
    1. Install a new gasket to the engine oil level sensor.
    2. Install the engine oil level sensor with the 4 bolts.

      Torque: 7.0 N.m (71 kgf/cm, 62 in.lbf) 

      HINT: 

      Be sure to clean the contact surface.

    3. Connect the engine oil level sensor connector.
  2. ADD ENGINE OIL 

    See step  7

  3. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  4. INSPECT FOR ENGINE OIL LEAK 

    See step  8

  5. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover) 

    Refer to PROCEDURE - Step 99

  6. INSTALL FRONT SUSPENSION MEMBER BRACE (w/ No. 2 Engine Under Cover) 

    Refer to PROCEDURE - Step 100

scientia non olet · About LEMON Manuals