Installation [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Install the 2 wire harness clamp brackets to the generator assembly with the 3 bolts.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
2. Install the generator assembly with the 2 bolts.
  Torque: 43 N.m (438 kgf/cm, 32 ft.lbf)
3. Engage the 4 wire harness clamps.
4. Connect the generator assembly connector.
5. Connect the wire harness to terminal B with the nut.
  Torque: 12 N.m (122 kgf/cm, 106 in.lbf)
6. Install the terminal cap.
7. Engage the 2 wire harness clamps.
INSTALL V-RIBBED BELT
Refer to INSTALLATION [08/2015 - ]
INSTALL AIR CLEANER ASSEMBLY WITH NO. 2 AIR CLEANER HOSE
Refer to PROCEDURE - Step 49 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 49 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 49 [09/2020 - ]
INSTALL INLET NO. 1 AIR CLEANER
Refer to PROCEDURE - Step 80 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 79 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 79 [09/2020 - ]
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 3 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 2 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 2 [09/2020 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2015 - 10/2016] , or refer to INITIALIZATION [10/2016 - 10/2017] , or refer to INITIALIZATION [10/2017 - 09/2020] , or refer to INITIALIZATION [09/2020 - 11/2021] , or refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]