Installation [10/2017 - ]: Procedure

1. Apply MP grease to the lip of a new rear engine oil seal.
   NOTE:

   Keep the lip free of foreign matter.

2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	-0.5 to 0.5mm

   • SST: 09223-15030 
   • SST: 09950-70010 
     1. 09951-07150

   Standard depth

   -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

   NOTE:

   • Wipe off extra grease of the crankshaft.
   • Keep the lip free of foreign matter.
   • Do not tap on the oil seal at an angle.

1. Using SST, hold the crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09213-70010 
     1. 09213-70020
   • SST: 09330-00021 
2. Clean the 8 bolts and 8 bolt holes.
3. Install the crank angle sensor plate, drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Crank Angle Sensor Plate
   *2	Drive Plate and Ring Gear
   *3	Rear drive plate Spacer
   	Automatic Transmission Side

   HINT: 

   As the crank angle sensor plate, drive plate and ring gear and rear drive plate spacer are not reversible, be sure to install it in the direction shown in the illustration.

4. Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Adhesive

   Adhesive

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

5. Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

   Torque: 83 N.m (846 kgf/cm, 61 ft.lbf) 

   Fig 1: Drive Plate And Ring Gear Sub-Assembly Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   Do not start the engine for at least an hour after installing the drive plate.

Refer to INSTALLATION [10/2016 - ]

Refer to PROCEDURE - Step 8 [10/2017 - 11/2021] , or refer to PROCEDURE - Step 8 [11/2021 - ]