LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine Starting System (8AR-FTS) - Service Information) >> Starter >> Installation [08/2015 - 10/2016] >> Procedure

Installation [08/2015 - 10/2016]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

    2. Connect terminal 30 with the nut.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

    3. Close the terminal cap.
    4. Connect the starter assembly connector.
  2. INSTALL NO. 2 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 77

  3. INSTALL FRONT SUSPENSION MEMBER BRACE 

    Refer to PROCEDURE - Step 78

  4. INSTALL ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 79

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2015 - 10/2016]

scientia non olet · About LEMON Manuals