LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System (8AR-FTS) - Service Information) >> Knock Sensor >> Removal [08/2015 - ] >> Procedure

Removal [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE INTAKE MANIFOLD 

    Refer to REMOVAL [08/2015 - ]

  2. REMOVE KNOCK SENSOR 
    1. Disconnect the knock sensor connector.
      GTY639801Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and knock sensor from the cylinder block sub-assembly.
      NOTE:

      If the knock sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals