LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Intake / Exhaust System (8AR-FTS) - Service Information) >> Turbocharger >> Removal [08/2015 - ] >> Procedure

Removal [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front and Rear Catalyst) 

    Refer to REMOVAL [08/2015 - ]

  2. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH 
    1. Remove the bolt and disengage the front engine mounting insulator from the front No. 1 engine mounting bracket LH.
      GTY654450Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and front No. 1 engine mounting bracket LH from the cylinder block sub-assembly.
      GTY657870Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE NO. 5 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Type A:
      GTY645593Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 5 bolts and No. 5 exhaust manifold heat insulator from the outlet compressor elbow and cylinder head sub-assembly.
    2. Type B:
      GTY791880Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 4 bolts and No. 5 exhaust manifold heat insulator from the outlet compressor elbow and cylinder head sub-assembly.
  4. DISCONNECT NO. 1 AIR TUBE 
    1. Loosen the hose clamp and remove the bolt to disconnect the No. 1 air tube from the intake air resonator.
      GTY645594Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE OUTLET COMPRESSOR ELBOW 
    1. Disengage the clamp and disconnect the vacuum transmitting hose assembly from the outlet compressor elbow.
      GTY677602Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts and outlet compressor elbow with intake air resonator from the turbocharger sub-assembly.
    3. Remove the outlet compressor gasket from the turbocharger sub-assembly.
  6. DISCONNECT NO. 4 TURBO WATER HOSE 
    1. Slide the clip and disconnect the No. 4 turbo water hose from the No. 1 turbo water pipe sub-assembly.
      GTY658402Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. DISCONNECT NO. 3 TURBO WATER HOSE 
    1. Slide the clip and disconnect the No. 3 turbo water hose from the No. 1 turbo water pipe sub-assembly.
      GTY658401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NO. 2 HEAT INSULATOR BRACKET 
    1. Remove the 2 bolts and No. 2 heat insulator bracket from the turbocharger sub-assembly and No. 1 heat insulator bracket.
      GTY678535Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 1 HEAT INSULATOR BRACKET 
    1. Remove the 2 bolts and No. 1 heat insulator bracket from the cylinder head sub-assembly.
      GTY639884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. DISCONNECT INLET TURBO OIL PIPE SUB-ASSEMBLY 
    1. Remove the 2 bolts, union bolt and disconnect the inlet turbo oil pipe sub-assembly.
      GTY657856Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the No. 1 union bolt gasket from the union bolt.
  11. REMOVE TURBOCHARGER SUB-ASSEMBLY 
    1. Disengage the wire harness clamp.
      GTY619603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the intake air control valve (air by-pass valve assembly) connector.
      GTY619601Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the vacuum transmitting hose assembly from the waste gate valve actuator with bracket assembly.
      GTY657843Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 4 nuts and turbocharger sub-assembly from the cylinder head sub-assembly.
      GTY639893Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
      GTY639897Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the outlet No. 1 turbo oil gasket from the inlet turbo oil pipe sub-assembly.
      GTY639898Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE NO. 4 TURBO WATER HOSE 
    1. Slide the clip and remove the No. 4 turbo water hose from the No. 1 turbo water pipe sub-assembly.
      GTY666788Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE NO. 3 TURBO WATER HOSE 
    1. Slide the clip and remove the No. 3 turbo water hose from the No. 1 turbo water pipe sub-assembly.
      GTY666787Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE INLET COMPRESSOR ELBOW 

    See step  2

  15. REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY 
    1. Remove the bolt, 2 nuts and No. 1 turbo water pipe sub-assembly from the turbocharger sub-assembly.
      GTY657857Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the water by-pass gasket from the turbocharger sub-assembly.
      GTY505860Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE INLET TURBO OIL PIPE SUB-ASSEMBLY 
    1. Remove the 2 nuts and inlet turbo oil pipe sub-assembly from the turbocharger sub-assembly.
      GTY519334Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the inlet turbo oil gasket from the turbocharger sub-assembly.
      GTY505858Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals