Installation [08/2015 - 10/2017]: Procedure

INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

Apply a light coat of engine oil to the threads and gasket seating surface of the fuel pressure pulsation damper assembly.

Install 2 new gaskets, the fuel tube sub-assembly and fuel pressure pulsation damper assembly to the fuel pump assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Gasket
*2	Fuel Pressure Pulsation Damper Assembly
*3	Fuel Tube Sub-assembly

Using SST, tighten the fuel pressure pulsation damper assembly to the fuel pump assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Length of SST 52 mm (2.05 in.)
*b	Length of Torque Wrench 180 mm (7.09 in.)

Without SST [Torque (N*m (kgf*cm, ft.*lbf))]

Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)

With SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]

Torque: 31 N*m (316 kgf*cm, 23 ft.*lbf)

HINT:

This torque value is effective when SST is parallel to the torque wrench.
The "with SST" torque value is effective when using SST with a fulcrum length of 52 mm (2.05 in.).
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).
If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.
Refer to PRECAUTION [08/2015 - 10/2016] , or refer to PRECAUTION [10/2016 - 10/2017]

INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 3
CONNECT NO. 2 VENTILATION HOSE
Refer to PROCEDURE - Step 4
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2015 - 10/2016] , or refer to INITIALIZATION [10/2016 - 10/2017]
INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 106 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 106 [10/2016 - 10/2017]