Installation [04/2013 - 08/2015]: Procedure

1. Apply a light coat of engine oil to the threads and gasket seating surface of the fuel pressure pulsation damper assembly.
2. Install 2 new gaskets, the fuel tube sub-assembly and fuel pressure pulsation damper assembly to the fuel pump assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Gasket
   *2	Fuel Pressure Pulsation Damper Assembly
   *3	Fuel Tube Sub-assembly

3. Using SST, tighten the fuel pressure pulsation damper assembly to the fuel pump assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Length of SST 52 mm (2.05 in.)
   *b	Length of Torque Wrench 180 mm (7.09 in.)

   • SST: 09612-24014 
     1. 09617-24011

   Without SST [Torque (N*m (kgf*cm, ft.*lbf))] 

   Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) 

   With SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))] 

   Torque: 31 N*m (316 kgf*cm, 23 ft.*lbf) 

   HINT: 

   • This torque value is effective when SST is parallel to the torque wrench.
   • The "with SST" torque value is effective when using SST with a fulcrum length of 52 mm (2.05 in.).
   • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).
   • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

     Refer to PRECAUTION [04/2013 - 08/2015]

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 105