Removal [04/2013 - 10/2017]: Procedure

Refer to REMOVAL [04/2013 - 10/2017]

See step  4

1. Disconnect the engine oil pressure switch assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt and disconnect the wire harness.

1. Using SST, hold the crankshaft pulley and loosen the crankshaft pulley bolt until only 2 or 3 threads are screwed into the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   *b	Turn

   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 
2. Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   *b	Turn

   • SST: 09950-50013 
     1. 09951-05010
     2. 09952-05010
     3. 09953-05010
     4. 09954-05021

   HINT: 

   Apply molybdenum grease to the threads and tip of SST (center bolt) prior to use.

1. Using a screwdriver, remove the crankshaft timing gear key from the crankshaft groove.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Protective Tape

   HINT: 

   Tape the screwdriver tip before use.

1. Using a screwdriver, pry out the timing gear case or timing chain case oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Protective Tape

   NOTE:

   After the removal, check the crankshaft for damage.

   If it is damaged, smooth the surface with 400-grit sandpaper.

   HINT: 

   Tape the screwdriver tip before use.