Installation [04/2013 - 10/2017]: Procedure

1. Set the V-ribbed belt onto every pulley.
   Fig 1: Engine Drive Belt Routing Diagram

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Water Pump Assembly
   *2	Generator Assembly
   *3	No. 2 Idler Pulley Sub-assembly
   *4	V-ribbed Belt Tensioner Assembly
   *5	Crankshaft Pulley
   *6	Compressor and Magnetic Clutch Assembly

   NOTE:

   • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and No. 2 idler pulley sub-assembly.
   • Check that the V-ribbed belt is properly set to each pulley.
2. While turning the V-ribbed belt tensioner assembly counterclockwise, remove the bar.
3. If it is difficult to install the V-ribbed belt, perform the following procedure.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Check that the V-ribbed belt fits properly in the ribbed grooves.

   HINT: 

   Make sure to check by hand that the V-ribbed belt has not slipped out of the grooves on the bottom of the crankshaft pulley.

Refer to PROCEDURE - Step 105 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 106 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 106 [10/2016 - 10/2017]

Refer to PROCEDURE - Step 75 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 76 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 77 [10/2016 - 10/2017]

Refer to PROCEDURE - Step 3 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 2 [10/2016 - 09/2020]