Installation [04/2013 - 10/2017]: Procedure

1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

   Adhesive

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

   NOTE:

   • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
   • Install the engine oil pressure switch assembly within 3 minutes after applying adhesive.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Adhesive 1324

2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

   Type A 

   Torque: 14.7 N*m (150 kgf*cm, 11 ft.*lbf) 

   Type B 

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Do not start the engine within 1 hour of installation.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Type A
   *b	Type B

3. Connect the engine oil pressure switch assembly connector.

See step  7[04/2013 - 08/2015], or see step  7[08/2015 - 10/2017]

Refer to PROCEDURE - Step 1

See step  8 [04/2013 - 08/2015], or see step  8[08/2015 - 10/2017]

Refer to PROCEDURE - Step 75 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 76 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 77 [10/2016 - 10/2017]

Refer to PROCEDURE - Step 3 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 2 [10/2016 - 09/2020]