Installation [04/2013 - 10/2017]: Procedure

1. Install the 2 lower radiator supports to the radiator assembly.

1. Install the 2 radiator support cushions to the radiator assembly.

1. Engage the 3 guides.
2. Engage the 3 claws and install the fan shroud assembly to the radiator assembly.
   NOTE:

   Do not damage the radiator assembly when installing the fan shroud assembly.

3. Install the radiator assembly with the fan assembly to the vehicle.
   NOTE:

   Do not apply excessive force to the condenser assembly or pipe when installing the radiator assembly.

1. Install the engine room ECU outlet duct to the fan shroud assembly.

1. Engage the 2 guides.
2. Engage the 2 claws and connect the cooler condenser assembly to the radiator assembly.
   NOTE:

   Do not damage the cooler condenser assembly or radiator assembly when installing the cooler condenser assembly.

1. Install the upper radiator support sub-assembly with the 5 bolts.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

2. Engage the 6 clamps and connect the wire harness to the upper radiator support sub-assembly.
3. Connect the 2 horn connectors.

1. Connect the cooling fan ECU connector.
2. Engage the 7 clamps and connect the engine room main wire from the upper radiator support sub-assembly.

1. Connect the No. 2 radiator hose to the radiator assembly and slide the clip to secure it.
2. Install a new radiator hose clamp to the fan shroud assembly.
3. Engage the clamp and connect the No. 2 radiator hose to the radiator hose clamp.

1. Install the No. 1 radiator hose to the radiator assembly and water inlet and slide the 2 clips to secure them.

1. Engage the 2 claws and install the radiator reserve tank assembly to the fan shroud assembly.
2. Connect the clamp and wire harness to the radiator reserve tank assembly.
3. Connect the radiator reserve tank hose to the water inlet and slide the clip to secure it.

Refer to PROCEDURE - Step 3 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 3 [10/2016 - 09/2019]

1. Engage the 2 clamps and connect the hood lock control cable assembly to the upper radiator support sub-assembly.

Refer to PROCEDURE - Step 4 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 4 [10/2016 - 09/2019]

Refer to PROCEDURE - Step 75 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 76 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 77 [10/2016 - 10/2017]

See step  5[04/2013 - 08/2015], or see step  5[08/2015 - 10/2017]

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 105 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 106 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 106 [10/2016 - 10/2017]

Refer to INSTALLATION [04/2013 - 10/2016] , or refer to INSTALLATION [10/2016 - 09/2020]

Refer to PROCEDURE - Step 3 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 2 [10/2016 - 09/2020]