Removal [04/2013 - 10/2016]: Procedure

PRECAUTION
Refer to PRECAUTION [04/2013 - 06/2014] , or refer to PRECAUTION [06/2014 - 10/2016]

NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [04/2013 - 08/2015] , or refer to PRECAUTION [08/2015 - 10/2016]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015] , or refer to INITIALIZATION [08/2015 - 10/2016]
REMOVE FRONT BUMPER ASSEMBLY
for Standard: Refer to REMOVAL [04/2013 - 10/2016]

for Sport Package: Refer to REMOVAL [04/2013 - 10/2016]

REMOVE UPPER FRONT FENDER PROTECTOR

Disengage the 3 clips to remove the upper front fender protector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE HEADLIGHT ASSEMBLY

WARNING:

The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.

Disconnect the 2 connectors.

	Bolt
	Screw

Remove the 2 bolts, screw and headlight assembly.