DTC B2250: Back Door Closer Operation Malfunction [09/2013 - ]: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [09/2013 - ]

NEXT: Go to next step 

1. Check for DTCs. Refer to DTC CHECK / CLEAR [09/2013 - ]

   OK

   DTC B2250 is not output.

NG → See step   3 

OK → See step   7 

1. Disconnect the U33 luggage closer motor connector.
2. Disconnect the a9 luggage compartment door lock connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   U33-16 (CSG) - a9- 4 (CPSE)	Always	Below 1 Ω
   U33-17 (CS2) - a9- 9 (CPS2)	Always	Below 1 Ω
   U33-18 (CS1) - a9- 2 (CSP1)	Always	Below 1 Ω
   U33-19 (CSV) - a9- 3 (CPS+)	Always	Below 1 Ω
   U33-16 (CSG) - Body ground	Always	10 kΩ or higher
   U33-17 (CS2) - Body ground	Always	10 kΩ or higher
   U33-18 (CS1) - Body ground	Always	10 kΩ or higher
   U33-19 (CSV) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Temporarily replace the luggage compartment door lock with a new or normally functioning one. Refer to REMOVAL [09/2013 - ] .

NEXT: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [09/2013 - ] .
2. Recheck for DTCs. Refer to DTC CHECK / CLEAR [09/2013 - ] .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC B2250 is output	B

B → See step   6 

A → END (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY WAS DEFECTIVE)