Removal [09/2013 - ]

DISABLE AUTO TILT AWAY FUNCTION
1. Disable the autoaway/return function by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS [09/2013 - ] .
  NOTE:
  Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
  
  HINT:
  
  Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.
2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
3. Turn the engine switch off.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL . Refer to REMOVAL [09/2013 - ] - Step 1
REMOVE INSTRUMENT PANEL FINISH PANEL END LH . Refer to REMOVAL [09/2013 - ] - Step 2
REMOVE INSTRUMENT SIDE PANEL LH . Refer to REMOVAL [09/2013 - ] - Step 12
REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 13
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 14
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 15
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 17
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL [09/2013 - ] - Step 18
REMOVE TRIP SWITCH

Fig 1: Removing Trip Switch
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using a screwdriver, detach the 2 claws and remove the trip switch.
  HINT:
  
  Tape the screwdriver tip before use.
  TEXT IN ILLUSTRATION
  
  *1 Protective Tape