SRS Warning Light does not Come ON: Procedure

1. Measure the voltage of the battery.

   Standard Voltage

   11 to 14 V

NG → See step   6 

OK: Go to next step 

1. Turn the engine switch off.
2. Disconnect the cable from the negative (-) battery terminal.
   NOTE:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. Check that the connector is properly connected to the combination meter assembly.

   OK

   The connector is properly connected.

   HINT: 

   If the connector is not connected securely, reconnect the connector and proceed to the next inspection.

4. Disconnect the connector from the combination meter assembly.
5. Check that the terminal of the connector is not damaged.

   OK

   The terminal is not deformed or damaged.

NG → REPLACE WIRE HARNESS 

OK: Go to next step 

1. Connect the cable to the negative (-) battery terminal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Turn the engine switch on (IG).
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F16-1 (IG+) - Body ground	Engine switch on (IG)	11 to 14 V
   F16-13 (B) - Body ground	Always	11 to 14 V

4. Turn the engine switch off.
5. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F16-6 (ES) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Combination Meter Assembly)

NG → REPLACE WIRE HARNESS 

OK: Go to next step 

1. Disconnect the cable from the negative (-) battery terminal.
   NOTE:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. Connect the connector to the combination meter assembly.
3. Disconnect the connector from the center airbag sensor assembly.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the engine switch on (IG).
6. Check the SRS warning light condition.

   OK

   After the primary check period, the SRS warning light goes off for approximately 10 seconds and turns back on.

   HINT: 

   The primary check period is approximately 6 seconds after the engine switch is turned to on (IG).

NG → See step   7 

OK → See step   5