DTC B1500: Fuel Sender Open Detected: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Check the values by referring to the table below.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Fuel Input	Fuel input signal/Min.: 0, Max.: 127.5	Current fuel level displayed	Unit: Liter

   Result

   Result	Proceed to
   Fuel level data can be displayed on the Techstream and DTC B1500 is output.	A
   Fuel level data cannot be displayed on the Techstream.	B

B → See step   2 

A → See step   6 

1. Disconnect the F16 connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F16-16 (FR) - F16-17 (FE)	Always	13.5 to 414.5 Ω

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Combination Meter Assembly)

NG → See step   3 

OK → See step   6 

1. Disconnect the P11 connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F16-16 (FR) - P11-2 (S)	Always	Below 1 Ω
   F16-16 (FR) - Body ground	Always	10 kΩ or higher
   F16-17 (FE) - P11-3 (FE)	Always	Below 1 Ω
   F16-17 (FE) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Combination Meter Assembly)
   *2	Front view of wire harness connector (to Fuel Suction Pump and Gauge Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the fuel sender gauge assembly. Refer to REMOVAL [03/2012 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Check that the float moves smoothly between E and F.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	Float level is F (upper)	13.5 to 16.5 Ω
   1 - 2	Float level is between F (upper) and E (lower)	13.5 to 414.5 Ω (Gradually changes)
   1 - 2	Float level is E (lower)	405.5 to 414.5 Ω

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Fuel Sender Gauge Assembly)

NG → See step   7 

OK: Go to next step 

1. Visually check for deformation on the fuel suction pump and gauge assembly connector.

   OK

   There is no deformation.

NG → See step   8 

OK → See step   6