Fuel Receiver Gauge Malfunction: Procedure
- CHECK FOR DTC
- Check for DTCs. Refer to DTC B1500: Fuel Sender Open Detected .RESULT
Result Proceed to DTC B1500 is not output A DTC B1500 is output B
B → See step 3
A: Go to next step
- Check for DTCs. Refer to DTC B1500: Fuel Sender Open Detected .
- PERFORM ACTIVE TEST USING TECHSTREAM (FUEL RECEIVER GAUGE ASSEMBLY)
- Operate the Techstream according to the display and select Active Test. Refer to DATA LIST / ACTIVE TEST [01/2012 - ]
.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2 or FULL Perform the test with the vehicle stopped and engine idling. OK
Needle indication is normal.
NG → See step 4
OK → See step 5
- Operate the Techstream according to the display and select Active Test. Refer to DATA LIST / ACTIVE TEST [01/2012 - ]
.
- GO TO DTC B1500. Refer to DTC B1500: Fuel Sender Open Detected
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [01/2012 - ]
- PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [01/2012 - ]