Installation [09/2012 - ]

INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
1. Check that the engine switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  WARNING:
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Push in the lock to connect the airbag connector.
  
  Fig 1: Installing Front Passenger Side Knee Airbag Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the airbag connector to the front passenger side knee airbag assembly.
  NOTE:
  When connecting airbag connector, take care not to damage the airbag wire harness.
5. Attach the claw to install the front passenger side knee airbag assembly.
6. Install the 3 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  NOTE:
  Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.
INSTALL LOWER INSTRUMENT PANEL
1. Attach the 2 claws and clip to install the lower instrument panel.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION [09/2012 - ] - Step 18
INSTALL INSTRUMENT SIDE PANEL RH . Refer to INSTALLATION [09/2012 - ] - Step 21
INSTALL INSTRUMENT PANEL FINISH PANEL END RH . Refer to INSTALLATION [09/2012 - ] - Step 12
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [09/2012 - ] .
CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [09/2012 - ]
INSTALL COWL TOP VENTILATOR LOUVER RH . Refer to INSTALLATION [09/2012 - ] - Step 17