Reassembly [09/2012 - ]

HINT: 

A bolt without a torque specification is shown in the standard bolt chart. Refer to SPECIFIED TORQUE FOR STANDARD BOLTS [09/2012 - ] .

1. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY 
   Fig 1: Installing No. 1 Instrument Panel Register Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Attach the 4 claws to install the No. 1 instrument panel register assembly.
2. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY 
   Fig 2: Installing No. 2 Instrument Panel Register Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Attach the 4 claws to install the No. 2 instrument panel register assembly.
3. INSTALL NO. 1 METER HOOD RETAINER 
   1. Install the 2 No. 1 meter hood retainers with the 2 screws.
4. INSTALL NO. 1 INSTRUMENT PANEL PIN 

   HINT: 

   Use the same procedure to install the No. 1 instrument panel pin on the other side.

   1. Install the No. 1 instrument panel pin with the screw.
5. INSTALL NO. 2 INSTRUMENT PANEL WIRE 
   1. w/o Ion Generator:

      Attach the wire harness clamp to install the No. 2 instrument panel wire.

   2. w/ Ion Generator:

      Attach the 5 wire harness clamps to install the No. 2 instrument panel wire.

6. INSTALL AUTOMATIC LIGHT CONTROL SENSOR 
   Fig 3: Installing Solar Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Attach the 2 claws to install the automatic light control sensor.
   2. Connect the connector.
7. INSTALL NAVIGATION ANTENNA ASSEMBLY  . Refer to INSTALLATION [09/2012 - ] - Step 1
8. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY  . Refer to INSTALLATION [09/2012 - ] - Step 1
9. INSTALL NO. 2 INSTRUMENT PANEL WIRE  . Refer to INSTALLATION [09/2012 - ] - Step 2
10. INSTALL ION GENERATOR SUB-ASSEMBLY (w/ Ion Generator)  . Refer to INSTALLATION [09/2012 - ] - Step 1
11. INSTALL NO. 2 HEATER TO REGISTER DUCT 
    1. Install the No. 2 heater to register duct with the 2 screws.
    2. w/ Ion Generator:

       Connect the hose to the ion generator sub-assembly.

12. INSTALL DEFROSTER NOZZLE ASSEMBLY 
    1. Install the defroster nozzle assembly with the 3 screws.
13. INSTALL NO. 3 HEATER TO REGISTER DUCT 
    1. Install the No. 3 heater to register duct with the 3 screws.
14. INSTALL NO. 1 HEATER TO REGISTER DUCT 
    1. Install the No. 1 heater to register duct with the 3 screws.
15. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT 
    1. Attach the claw to install the No. 2 side defroster nozzle duct.
    2. Install the screw.
16. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT 
    1. Attach the claw to install the No. 1 side defroster nozzle duct.
    2. Install the screw.
17. INSTALL NO. 1 COMBINATION METER BRACKET 
    1. Install the No. 1 combination meter bracket.