Meter Illumination is Always Dark: Procedure

1. Check for DTC. Refer to DIAGNOSIS SYSTEM [09/2012 - ] .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   CAN communication system DTC is output	B
   Lighting system DTC (B1244) is output	C

B → See step   5 

C → See step   6 

A: Go to next step 

1. Operate the Techstream according to the display and select "Active Test".

   OK

   Meter illumination is dimmed when the dimmer switch is ON.

   MAIN BODY
   
   

   Tester Display	Test Part	Control Range
   Dimmer signal	Dimmer switch	ON or OFF

   HINT: 

   Refer to the sensitivity setting in the customization table of the automatic light control system. Refer to CUSTOMIZE PARAMETERS [09/2012 - ] .

NG → See step   3 

OK → See step   7 

1. Temporarily replace the No. 1 meter ECU with a new one. Refer to DISASSEMBLY [09/2012 - ] .

NEXT: Go to next step 

1. Check that the operation of the No. 1 meter ECU returns to normal. Refer to OPERATION CHECK [09/2012 - ] .

   OK

   Operation of No. 1 meter ECU returns to normal.

NG → REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK) 

OK → END (NO. 1 METER ECU IS DEFECTIVE)