Entire Combination Meter does not Operate: Procedure

1. Disconnect the G3 combination meter connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.
   STANDARD RESISTANCE
   
   

   Tester Connection	Condition	Specified Condition
   G3-21 (E2) - Body ground	Always	Below 1 Ω
   G3-1 (EP) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.
   STANDARD VOLTAGE
   
   

   Tester Connection	Condition	Specified Condition
   G3-27 (IG+) - Body ground	Engine switch on (IG)	11 to 14 V
   G3-25 (B) - Body ground	Always	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2