Accessory Meter does not Illuminate: Procedure

1. Disconnect the H26 accessory meter connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage according to the value(s) in the table below.
   STANDARD VOLTAGE
   
   

   Tester Connection	Condition	Specified Condition
   H26-1 (IG) - Body ground	Engine switch on (IG)	11 to 14 V
   H26-9 (+B) - Body ground	Always	11 to 14 V

3. Measure the resistance according to the value(s) in the table below.
   STANDARD RESISTANCE
   
   

   Tester Connection	Condition	Specified Condition
   H26-16 (GND) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Accessory Meter)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2