DTC B1925/78: Short in Rear Pretensioner Squib LH Circuit; DTC B1926/78: Open in Rear Pretensioner Squib LH Circuit; DTC B1927/78: Short to GND in Rear Pretensioner Squib LH Circuit; DTC B1928/78: Short to B+ in Rear Pretensioner Squib LH Circuit: Description
The rear seat belt pretensioner LH circuit consists of the center airbag sensor assembly and rear seat 3 point type outer belt assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
These DTCs are stored when a malfunction is detected in the rear seat belt pretensioner LH circuit.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1925/78 |
One of the following conditions is met:
- The center airbag sensor assembly detects a line short circuit signal 5 times in the rear seat belt pretensioner LH circuit during the primary check.
- A rear seat belt pretensioner LH malfunction.
- A center airbag sensor assembly malfunction.
|
- No. 2 floor wire
- Rear seat 3 point type outer belt assembly LH (Rear seat belt pretensioner LH)
- Center airbag sensor assembly
|
| B1926/78 |
One of the following conditions is met:
- The center airbag sensor assembly detects an open circuit signal in the rear seat belt pretensioner LH circuit for 2 seconds.
- A rear seat belt pretensioner LH malfunction.
- A center airbag sensor assembly malfunction.
|
| B1927/78 |
One of the following conditions is met:
- The center airbag sensor assembly detects a short circuit to ground signal in the rear seat belt pretensioner LH circuit for 0.5 seconds.
- A rear seat belt pretensioner LH malfunction.
- A center airbag sensor assembly malfunction.
|
| B1928/78 |
One of the following conditions is met:
- The center airbag sensor assembly detects a short circuit to B+ signal in the rear seat belt pretensioner LH circuit for 0.5 seconds.
- A rear seat belt pretensioner LH malfunction.
- A center airbag sensor assembly malfunction.
|