DTC C195A: Malfunction in Signal from Yaw Rate Sensor to Front Active Stabilizer Control ECU: Procedure

CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

Turn the power switch OFF.
Connect the Techstream to the DLC3.
Turn the power switch ON (READY) and the Techstream on.

Check for DTC. Refer to DTC CHECK / CLEAR .

Result	Proceed to
DTC is not output	A
DTC is output	B

B → See step 3

A → See step 2

REPLACE FRONT ACTIVE STABILIZER CONTROL ECU. Refer to REMOVAL
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (DIAGNOSTIC TROUBLE CODE CHART). Refer to DIAGNOSTIC TROUBLE CODE CHART