DTC C194F: Operation of Static Test Mode is Incomplete (Test Mode DTC); DTC C1950: Front Stabilizer Target Angle Not Attained (Test Mode DTC); DTC C1951: Rear Stabilizer Target Angle Not Attained (Test Mode DTC): Procedure

1. Turn the power switch OFF.
2. Connect the Techstream to the DLC3.
3. Turn the power switch ON (READY) and the Techstream on.
4. Perform the Active Test. Refer to DATA LIST / ACTIVE TEST .
5. After the Active Test ends, check that test mode DTCs are erased.

   HINT: 

   If the Active Test cannot be performed, turn the power switch OFF and ON (READY) again, and perform the Active Test. If the Active Test still cannot be performed, there may be a system malfunction.

   RESULT
   
   

   Result	Proceed to
   Even if Active Test is repeatedly attempted, Active Test cannot be performed (test mode DTC C194F and/or C1950 are output)	A
   Even if Active Test is repeatedly attempted, Active Test cannot be performed (test mode DTC C194F and/or C1951 are output)	B
   Active Test operates and test mode DTCs are not output	C

B → See step   3 

C → END 

A → See step   2