DTC C190C: Rear Metal Board Overheat; DTC C190D: Rear Control Board Overheat: Procedure
- CHECK MULTI-INFORMATION DISPLAY
- Turn the power switch OFF and wait 30 minutes or more.
- Check if "Check Active Stabilizer Suspension System" is still displayed on the multi-information display.
HINT:
30 minutes is the approximate amount of time that is required for the rear active stabilizer control ECU to cool down sufficiently.
RESULTResult Proceed to Displayed A Not displayed B
B → See step 3
A: Go to next step
- INSPECT SURROUNDING CONDITIONS (AMBIENT TEMPERATURE)
- Check the temperature around the rear active stabilizer control ECU.
HINT:
If there are factors causing a high temperature in the rear active stabilizer control ECU, eliminate those factors, wait for the ECU to cool down, and recheck for the DTC.
OK
No factors causing high temperatures
NG → REPAIR MALFUNCTIONING AREA
OK: Go to next step
- Check the temperature around the rear active stabilizer control ECU.
- INTERCHANGE FRONT AND REAR ACTIVE STABILIZER CONTROL ECU
- Turn the power switch OFF.
- Interchange the rear active stabilizer control ECU with the front active stabilizer control ECU, and install them securely.
HINT:
- Interchange the front and rear active stabilizer control ECUs and check for DTCs. After interchanging the ECUs, if a front stabilizer DTC is displayed, it can be determined that the rear active stabilizer control ECU is malfunctioning.
- For the ECU removal and installation procedures, refer to the front ECU procedures. Refer to REMOVAL or the rear ECU procedures. Refer to REMOVAL .
NEXT: Go to next step
- CLEAR DTC
- Turn the power switch OFF.
- Connect the Techstream to the DLC3.
- Turn the power switch ON (IG) and the Techstream on.
- Clear the DTC. Refer to DTC CHECK / CLEAR .
NEXT: Go to next step
- CHECK OPERATION OF REAR ACTIVE STABILIZER CONTROL ECU
- Turn the power switch OFF.
- Connect the Techstream to the DLC3.
- Turn the power switch ON (READY) and wait 30 seconds or more. Then check for front stabilizer DTCs. Refer to DTC CHECK / CLEAR
.
OK
DTC C1934 and/or C1935 are not output
NG → See step 6
OK → RETURNS TO NORMAL OPERATION (SYSTEM RETURNS TO NORMAL DUE TO RETURN OF METAL BOARD OR CONTROL BOARD TO NORMAL TEMPERATURE)
- REPLACE REAR ACTIVE STABILIZER CONTROL ECU. Refer to REMOVAL