Hybrid System Indicator Malfunction: Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check for the DTC. Refer to DTC CHECK / CLEAR
.RESULT
Result Proceed to DTC is not output A CAN communication system DTC is output B Hybrid control system DTC is output C
B → See step 4
C → See step 5
A: Go to next step
- Check for the DTC. Refer to DTC CHECK / CLEAR
.
- PERFORM ACTIVE TEST USING TECHSTREAM (HYBRID SYSTEM INDICATOR)
- Operate the Techstream according to the display and select "Active Test".COMBINATION METER:
Tester Display Test Part Control Range Diagnostic Note Hybrid system indicator Hybrid system indicator MIN, -50, 0, 100, 200, 300, 400, MAX (%) Perform test with the vehicle stopped and engine idling OK
Needle indication is normal.
NG → See step 6
OK → See step 3
- Operate the Techstream according to the display and select "Active Test".
- Go to HYBRID CONTROL SYSTEM. Refer to PROBLEM SYMPTOMS TABLE
- Go to CAN COMMUNICATION SYSTEM. Refer to PRECAUTION
- Go to HYBRID CONTROL SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL